Author:
crank
Download:
This file has been removed from public access at the request of the US Department of Defense Trade Controls. Until further notice, the United States government claims control of the information.
14 thoughts on “AR-15 Magazine”
You must log in to post a comment.
hi there – i think you are missing the floorplate STL. I see two of the “magazine body” STLs
Fixed! Thanks for pointing this out.
Pingback: Home built AK magazines? - INGunOwners
For some reason when i open the stl’s they are extreamly small…. I have tried it with slic3r and netfabb. Anyone got any idea’s? Also i noticed the printable plastic spring is missing.
i had the same issue, very difficult to scale them correctly.
In the scale menu, try pushing “Inches to MM.” If you don’t have that button you can scale by 25.4 how you would traditionally.
Yup that does it…. Go figure.
I have contacted them on twitter to see if they can give us any pointers. BTW good seeing you again SlvrS3 hope all is well. You still IRC any?
I hope they get back to you. It would be very helpful. We’ll chat in IRC cheers
Am I blind, or is the file for the spring not available here?
Read the comments here http://defcad.org/ar-15-magazine-30-round-mag/
Ok. The picture showed a printed spring, that’s what had me confused.
Just printed with the 25.4 suggested scaling and the magazine is 2mm too long. My calibration is correct on the printer. All other dimensions are great and spot on…
What orientation did you guys use to print the follower? I tried printing it upside down so it wouldn’t need so much support to print it. But when I printed it the top of the follower printed flat. has anyone else had this problem?